Under COSHH Regulations 2002 (Regulation 6), employers must conduct a task-specific risk assessment for AdBlue (AUS 32, ISO 22241) storage and handling, implementing secondary containment bunding per Environment Agency PPG2/GPP2 (110% capacity) and Water Resources Act 1991 to prevent aquatic pollution. A manufacturer's Safety Data Sheet (SDS) alone does NOT satisfy UK HSE legal requirements; a site-specific COSHH assessment must evaluate exposure routes, WELs (EH40/2005: urea dust 10 mg/m³ TWA), and engineering controls to reduce residual risk to ≤6 (5×5 matrix). AdBlue (32.5% urea solution, CLP classification: not classified as hazardous under CLP Regulation (EC) 1272/2008, but alkaline pH 9–10 presents skin/eye irritation risk) requires IBC bunding, spill kits, and emergency eyewash stations. This audit-grade template provides BS EN-coded PPE, 5×5 risk scoring, and step-by-step LOTO procedures for bulk storage, decanting, and spill response, ensuring compliance with COSHH 2002, ISO 22241, EA bunding guidance, and Water Resources Act 1991 for UK construction, logistics, and fleet operations.
| Identified Hazard & Harm | Initial Risk (L×S) | Mandatory Engineering, Isolation & Procedural Controls | Residual Risk |
|---|---|---|---|
| 1. Skin and eye contact with alkaline AdBlue solution (pH 9–10) during IBC decanting, hose connection, or spill response Harm: Chemical burns, dermatitis, conjunctivitis; prolonged skin contact causes irritation and drying; eye splash requires immediate 15-minute irrigation to prevent corneal damage | 4 × 3 = 12 | Mandatory BS EN 166 goggles and BS EN ISO 374 nitrile gloves; emergency eyewash station (BS EN 15154-2) within 10 m; closed-loop transfer pump with dry-break couplings to eliminate manual handling; SDS and COSHH assessment briefing before task; spill kit with pH neutralisation granules; immediate first aid: irrigate eyes/skin for 15 minutes, remove contaminated clothing. | 3 × 2 = 6 |
| 2. Environmental pollution: AdBlue spillage entering surface water drains, watercourses, or groundwater (ammonia toxicity to aquatic life) Harm: Prosecution under Water Resources Act 1991 (Section 85 offence, unlimited fine); ecological damage (ammonia LC50 for fish 0.2–2.0 mg/L); Environment Agency enforcement notice and remediation costs | 4 × 4 = 16 | Secondary containment bund (110% IBC capacity, 1100 litres minimum) per EA PPG2/GPP2; impermeable polyethylene or steel construction; weekly bund integrity inspection (cracks, leaks, drain valve locked shut); drain covers and spill kit within 5 m; emergency spill procedure: contain with absorbent booms, notify Environment Agency incident hotline 0800 807060 if >10 litres enters drain; LOTO on bund drain valve (locked closed, key control). | 2 × 3 = 6 |
| 3. Manual handling injury: lifting/positioning 1000-litre IBC (gross weight 1050–1100 kg) using forklift or pallet truck Harm: Crush injuries, fractures, amputations if IBC falls or tips; musculoskeletal disorders from awkward postures during hose connection; fatality risk if operator struck by moving IBC | 3 × 4 = 12 | Certified forklift operator (RTITB/ITSSAR) only; IBC placed on level, load-rated surface (minimum 1500 kg/m²); wheel chocks and parking brake applied; exclusion zone (3 m radius) during lifting; two-person task for hose connection (one operates valve, one steadies hose); IBC integrity check (no cracks, pallet damage) before movement; LOLER-compliant lifting equipment inspection every 6 months. | 2 × 3 = 6 |
| 4. Ammonia vapour release from thermal decomposition (AdBlue stored above 30°C or in direct sunlight) or contamination with incompatible substances Harm: Inhalation of ammonia gas (UN 1005, Class 2.3 toxic gas): respiratory irritation, pulmonary oedema at >300 ppm; WEL 25 ppm 8-hr TWA, 35 ppm 15-min STEL (EH40/2005); confined space asphyxiation risk | 3 × 3 = 9 | Store IBC in shaded, ventilated area (temperature <25°C); UV-resistant IBC cover or indoor storage; segregate from acids, oxidisers, and fuels (minimum 3 m separation); temperature monitoring (weekly checks, log recorded); ventilation rate ≥5 air changes/hour if indoors; gas detection (ammonia monitor, alarm set at 25 ppm) for enclosed storage; emergency procedure: evacuate, ventilate, do not enter without BA (Breathing Apparatus) if >50 ppm detected. | 2 × 2 = 4 |
| 5. Slips, trips, and falls on AdBlue spillages (urea solution creates slippery surface) or uneven bund access Harm: Fractures, head injuries, lacerations; secondary risk of falling into bund or striking IBC valve; lost-time injury (average 28 days off work for slip-related fracture) | 4 × 2 = 8 | Anti-slip matting around IBC base and bund access points; immediate spill clean-up protocol (absorbent pads, wet floor signs, cordon 2 m radius); weekly housekeeping inspection (remove trip hazards, check lighting ≥200 lux); step-over bund with handrail (if bund wall >150 mm height); non-slip safety boots (BS EN ISO 20345 S5 SRC); pre-task visual inspection for leaks/drips from valves. | 3 × 2 = 6 |
Conduct toolbox talk covering COSHH assessment, SDS (Section 4: First Aid, Section 8: Exposure Controls), and emergency procedures. Issue Permit-to-Work if required by site rules. Inspect secondary containment bund: confirm 110% capacity (1100 litres minimum for 1000 L IBC), no cracks or leaks, drain valve locked shut (LOTO applied, key with supervisor). Verify emergency eyewash station functional (15-minute supply, weekly flush log up to date). Check weather: do not proceed if temperature <0°C (freezing risk) or >30°C (ammonia release risk). Confirm spill kit (20 L absorbent capacity, drain covers, PPE) within 5 m. Establish 3 m exclusion zone with barriers/cones.
Certified forklift operator only (RTITB/ITSSAR card verified). Inspect IBC before lift: check for cracks, pallet damage, valve integrity, and ISO 22241 certification label. Lift IBC slowly (max speed 5 km/h), keeping forks fully inserted under pallet. Position IBC centrally in bund on level surface (check with spirit level; max 2° tilt). Apply wheel chocks if IBC on wheeled pallet. Ensure fill port and discharge valve accessible without reaching over bund wall. Confirm IBC stable before removing forklift. Record IBC batch number, delivery date, and expiry date (ISO 22241: 12-month shelf life) in site register.
All personnel don full PPE: BS EN ISO 374 nitrile gloves, BS EN 166 goggles, BS EN ISO 20345 S5 boots, Type 4/6 coveralls or apron. Inspect transfer pump (polypropylene/PVDF wetted parts, AdBlue-compatible) and hoses for cracks or contamination. Connect grounding/bonding cable between IBC and receiving vessel to prevent static discharge (resistance <10 ohms, verify with multimeter). Attach dry-break coupling to IBC discharge valve (bottom outlet). Place drip tray (minimum 10 L capacity) under connection point. Confirm receiving vessel has adequate capacity and is also within secondary containment or over drip tray.
Two-person operation: Operator A controls pump and valves; Operator B monitors for leaks and maintains exclusion zone. Slowly open IBC discharge valve (quarter-turn increments) to prime pump. Start transfer pump at low flow rate (max 20 L/min to prevent splashing). Operator B continuously observes hose connections, bund area, and receiving vessel level. Do NOT leave transfer unattended. If leak detected, immediately close IBC valve, stop pump, and deploy spill kit. Monitor for ammonia odour (sharp, pungent smell indicates decomposition—stop transfer and ventilate). Record volume transferred in site log.
Close IBC discharge valve fully (hand-tight only, do not over-torque). Stop pump and disconnect hoses using dry-break couplings (minimises drips). Drain residual AdBlue from hoses into drip tray. Remove bonding cable. Inspect bund and surrounding area for spills: clean immediately with absorbent pads, dispose as non-hazardous waste (AdBlue is biodegradable but must not enter drains). Rinse gloves and goggles with water before removal. Wash hands thoroughly with soap and water. Return spill kit to designated location, replenish used absorbents. Record transfer completion time and any incidents in Permit-to-Work.
Inspect IBC for leaks from valve or seams (check daily for first 3 days after new IBC installed). Confirm bund drain valve still locked shut (LOTO in place). Check emergency eyewash station used/not used; if used, record in First Aid log and refill. Inspect transfer pump and hoses: clean with water, check for wear, store in designated area away from sunlight. Update COSHH assessment record: note volume transferred, any near-misses, PPE effectiveness. Schedule next weekly bund inspection (add to maintenance calendar). Debrief team: discuss any improvements to procedure. File Permit-to-Work and transfer log for audit trail (retain 3 years minimum per COSHH Regulation 12).
**EMERGENCY CONTACTS:** Dial 999 for medical emergency (ambulance). Environment Agency Incident Hotline: 0800 807060 (24/7) for spills >10 litres entering drains/watercourses. Poison Centre: 0344 892 0111 (NHS 111 for non-urgent). Site Emergency Coordinator: [Insert name/number]. **FIRST AID (per AdBlue SDS Section 4):** *Skin Contact:* Remove contaminated clothing immediately. Wash affected area with soap and water for at least 15 minutes. If irritation persists, seek medical attention. *Eye Contact:* Rinse cautiously with water for at least 15 minutes, holding eyelids open. Remove contact lenses if present and easy to do. Seek immediate medical attention—AdBlue alkalinity (pH 9–10) can cause corneal damage. *Inhalation (ammonia vapour):* Move casualty to fresh air immediately. If breathing is difficult, administer oxygen (trained first aider only). If not breathing, commence CPR. Seek urgent medical attention—ammonia inhalation can cause pulmonary oedema (delayed onset up to 48 hours). *Ingestion:* Rinse mouth with water. Do NOT induce vomiting. Give small sips of water if conscious. Seek immediate medical attention. **SPILL RESPONSE:** Minor spill (<10 L): Cordon area 2 m radius. Don PPE (gloves, goggles, boots). Cover nearby drains with mats. Absorb with spill kit pads/granules. Collect waste in sealed bag labelled 'AdBlue Waste—Non-Hazardous'. Rinse area with water (collect rinse water in bund, do not allow to drain). Major spill (>10 L or entering drain): Evacuate area, establish 10 m exclusion zone. Notify Environment Agency 0800 807060 immediately (legal duty under Water Resources Act 1991 Section 85). Deploy drain covers and absorbent booms. Do NOT hose down—this spreads contamination. Engage specialist spill response contractor if >100 L or watercourse affected. **AMMONIA VAPOUR RELEASE:** Evacuate area if ammonia odour strong (>25 ppm WEL). Do not re-enter without gas monitor and BA (Breathing Apparatus) if >50 ppm. Ventilate naturally (open doors/windows) or use forced ventilation (explosion-proof fans). Identify source (overheated IBC, contamination) and isolate. Monitor with calibrated ammonia detector before permitting re-entry. **FIRE:** AdBlue is non-flammable, but thermal decomposition above 30°C releases ammonia (flammable gas, LEL 15%). Use water spray to cool IBC if exposed to fire. Evacuate if ammonia detected. Firefighters must wear BA. **ENVIRONMENTAL INCIDENT:** If AdBlue enters watercourse, immediately notify Environment Agency and local water company. Deploy absorbent booms downstream. Do NOT use detergents or dispersants. Collect contaminated soil/water for specialist disposal. Expect EA investigation and potential prosecution (Section 85 offence: unlimited fine, director liability). Document incident with photos, witness statements, and timeline for legal defence.
| Operative / Supervisor Name | Trade / Role & CSCS No. | Signature | Date & Time |
|---|---|---|---|
| 1. (Site Supervisor): | |||
| 2. | |||
| 3. | |||
| 4. |
Need site-specific compliance documentation instead of a static template? Explore the core SafeSequence® UK software modules hosted in AWS London (eu-west-2):